Fix endstops enable behavior during probing

Fix a bug introduced in #9582

Marlin/src/module/probe.cpp

@@ -543,15 +543,14 @@ static bool do_probe_move(const float z, const float fr_mm_s) {
       tmc_stallguard(stepperY);
     #endif
     tmc_stallguard(stepperZ);
+    endstops.enable(true);
   #endif
 
   #if QUIET_PROBING
     probing_pause(true);
   #endif
 
-  endstops.enable(true);
+  // Move down until the probe is triggered
-
-  // Move down until probe triggered
   do_blocking_move_to_z(z, fr_mm_s);
 
   // Check to see if the probe was triggered
@@ -575,6 +574,7 @@ static bool do_probe_move(const float z, const float fr_mm_s) {
 
   // Re-enable stealthChop if used. Disable diag1 pin on driver.
   #if ENABLED(SENSORLESS_PROBING)
+    endstops.not_homing();
     #if ENABLED(DELTA)
       tmc_stallguard(stepperX, false);
       tmc_stallguard(stepperY, false);

Marlin/src/module/stepper.cpp

@@ -2098,7 +2098,6 @@ void Stepper::init() {
 
   ENABLE_STEPPER_DRIVER_INTERRUPT();
 
-  endstops.enable(true); // Start with endstops active. After homing they can be disabled
   sei();
   set_directions(); // Init directions to last_direction_bits = 0  Keeps Z from being reversed
 }