format

README.md

@@ -1,8 +1,11 @@
-WARNING: THIS IN A PROCESS OF HEAVY OVERWORKING.
+
+WARNING: 
+--------
+THIS IN A PROCESS OF HEAVY OVERWORKING.
 DO NOT USE THIS ON YOUR MACHINE UNTIL FURTHER NOTICE!!!
 
-===========================================
-
+Quick Information
+===================
 This RepRap firmware is a mashup between <a href="https://github.com/kliment/Sprinter">Sprinter</a>, <a href="https://github.com/simen/grbl/tree">grbl</a> and many original parts.
 
 Derived from Sprinter and Grbl by Erik van der Zalm.
@@ -40,7 +43,6 @@ This firmware is optimized for Ultimaker's gen6 electronics (including the Ultim
 The default baudrate is 250000. This baudrate has less jitter and hence errors than the usual 115200 baud, but is less supported by drivers and host-environments.
 
 
-========================================================================================
 Differences and additions to the already good Sprinter firmware:
 ================================================================
 
@@ -114,7 +116,6 @@ Interrupt based temperature measurements:
 An interrupt is used to manage ADC conversions, and enforce checking for critical temperatures.
 This leads to less blocking in the heater management routine.
 
-========================================================================================
 Non-standard M-Codes, different to an old version of sprinter:
 ==============================================================
 G2  - CW ARC